ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34

ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34_141

ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34_143

TM-5-3805-261-34 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
97

TM 5-3805-261-34 ENGINE MAINTENANCE. (cont) 3-12. Rocker Arm Assembly. (Sheet 6 of 13) CLEANING Clean all parts. Refer to Chapter 2. INSPECTION Inspect all parts. Refer to Chapter 2. INSTALLATION 1. Install two new plugs (56) in ends of shaft (55, Figure 3-59). Tap in with hammer until flush with ends of shaft. 2. Install ring (54), washer (53), spring (52) and washer (51) on shaft (55, Figure 3-55). 3. Install screw (50) and lock nut (49) in arm (48). Loosely tighten lock nut (49). 4. Install items 50 thru 48 as an assembly (Figure 3-58). 5. Position bracket (45) on shaft (55, Figure 3- 55). Aline bracket (45) with large hole on end. 6. Using hammer, install dowel (47) in bracket (45). Dowel (47) must extend 0.378 inch out of bracket (45). 7. Install new preformed packing (46) in bracket (45). Go to Sheet 7 3-70 Figure 3-58. Figure 3-55. Figure 3-59.

Privacy Statement
Press Release
Contact