TM 5-3805-261-23-2
CIRCLE ASSEMBLY REPLACEMENT - CONTINUED
0344 00
CLEANING AND INSPECTION
Clean and inspect all parts in accordance with WP 0020 00.
INSTALLATION
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death to per-
sonnel.
NOTE
Circle weighs 1,050 lb (476 kg).
1.
Attach sling to circle (11) under machine.
SLING
2.
Raise circle (11) into mounting position under
23 (HIDDEN)
machine.
11
3.
Support circle (11) with jack stands.
4.
Turn battery disconnect switch to the ON position and
start engine (TM 5-3805-261-10).
5.
Lower drawbar assembly (2) into position over circle
(11). Move machine slowly forward to engage circle
drive motor pinion (23) into circle (11).
6.
Stop engine.
2
397-1698
JACK STANDS
0344 00-4