TM 5-3805-261-23-2
BLADE BRACKETS REPLACEMENT - CONTINUED
0343 00
INSTALLATION - CONTINUED
NOTE
SLING
2
Old style bracket weighs 72 lb (33 kg);
new style bracket weighs 50 lb (23 kg).
10.
Attach sling to bracket (1).
3
11.
Install two washers (11). Use washers as required to
get sliding fit of bracket (1) with maximum 0.07 in.
(1.8 mm) clearance between bracket and circle wear
4
1
plate.
5
12.
Install bracket (1).
6
13.
Install bolt (2), washers (4 and 5), and nut (6).
7
14.
Back out nut (12) to make contact with bracket (1).
15.
Install nut (3) and tighten to 1,200 lb-ft (1,627 Nm).
11
8
16.
Install washer (7) and nut (9) to bar (10). Tighten nut
10
to remove any clearance, then back off enough to per-
mit installation of new cotter pin (8).
9
OLD STYLE BRACKET SHOWN
17.
Install new cotter pin (8).
397-1690
18.
Remove rope and sling.
19.
Install side shift cylinder (WP 0337 00).
ROPE
20.
Install blade tip cylinder (WP 0334 00).
21.
Install blade assembly (WP 0259 00).
12
13
14
16
15
397-1691
END OF WORK PACKAGE
0343 00-5/(-6 Blank)
