TM 5-3805-261-23-2
GOVERNOR CONTROLS MAINTENANCE - CONTINUED
0282 00
ADJUSTMENT - CONTINUED
9.
Disconnect cable end (53) from housing (23) at engine.
10.
Disconnect rod (101).
11.
Adjust length between bolt holes of rod (101) to 13.81 in. (35.1 cm).
NOTE
On machines with high detent force, when going from low idle to shut off, distance between treadle lever
and floor plate can be increased to 2 in. (5 cm) to allow for needed cable stretch.
12.
Install rod (101) and adjust linkage low idle stop (151) so that treadle lever (96) is 1.5 in. (3.8 cm) below floor plate.
This is low idle position of pedal (96).
13.
Adjust length between pin holes of rod (104) to 17.53 in. (44.5 cm). When governor control linkage is against low idle
stop (151), governor control handle (152) will be positioned approximately 30 degrees from vertical.
152
SHUT-OFF
LOW IDLE
0.38 IN.
104
(9.7 MM)
HIGH IDLE
ENCLOSED ROPS
0.19 IN.
96
(4.8 MM)
151
OPEN ROPS
1.5 IN.
(3.8 CM)
53
397-2281
101
23
0.75 IN.
(19.0 MM)
0282 00-25