TM 5-3805-261-23-2
GOVERNOR CONTROLS MAINTENANCE - CONTINUED
0282 00
INSTALLATION - CONTINUED
47.
Install two new tie straps (52), and bearings (50 and
50
51), if removed. Drive new bearings on stamped side
36
into housing (36).
51
52
397-1425
48.
Install bolt (34) in lever (48).
34
48
397-1424
49.
Position shaft (35) in housing (36).
35
50.
Install key (38) in shaft (35).
36
51.
Install lever (48) on shaft (35) in housing (36).
52.
Install shaft (35) into housing (36).
53.
Tighten bolt (34).
54.
Position cable end (37) in housing (36).
34
55.
Install two nuts (43).
56.
Install nut (44), actuator (45), and rod end (42) on
37
48
cable end (37).
47
57.
Align lever (48) and rod end (42).
38
46
58.
Install two springs (39), washer (40), and bolt (41).
39
59.
Install nut (46) and bolt (47) in actuator (45).
40
45
41
44
42
43
397-1423
0282 00-20