TM 5-3805-261-23-2
EXHAUST MANIFOLD REPLACEMENT - CONTINUED
0277 00
REMOVAL - CONTINUED
CAUTION
Remove studs only if inspection proves replacement is necessary.
4.
Remove manifold (1) and four gaskets (16). Discard
1
gaskets.
5.
Remove stud (13), four studs (14), and three studs (15)
16
from right side of cylinder head, if necessary. Replace
if cracked, broken, heat damaged, or if threads are
damaged.
15
397-1340
14
13
CLEANING AND INSPECTION
Clean and inspect all parts in accordance with WP 0020 00.
INSTALLATION
1.
Install three studs (15), four studs (14), and stud (13)
1
on right side of cylinder head, if removed. Apply anti-
seize compound to half of studs (13, 14, and 15) being
12
installed in cylinder head. Tighten studs to 20 lb-ft (27
11
Nm).
10
2.
Install four new gaskets (16) on studs (13, 14, and 15)
9
on top-right of engine.
8
3.
Install manifold (1).
4.
Install three washers (11), washer (2), nut (3), and four
nuts (10). Tighten nuts to 32 lb-ft (43 Nm).
5.
Install four washers (12), two brackets (4), four wash-
2
ers (9), and nuts (8). Tighten nuts to 32 lb-ft (43 Nm).
3
6.
Install shield (5), two washers (6), and bolts (7).
4
6
7
5
397-1339
NOTE
If disconnected, connect primary fuel filter/priming pump (WP 0046 00).
7.
Install fuel injection lines (WP 0035 00).
8.
Install turbocharger (WP 0283 00).
9.
END OF WORK PACKAGE
0277 00-2
