TM 5-3805-261-23-2
OIL PUMP AND LINES REPLACEMENT - CONTINUED
0276 00
INSTALLATION - CONTINUED
16.
Turn balancer shafts (29) so that the flat sides of shaft
face the opposite direction of oil pan plate (28).
17.
Install two 3/8-16NC 1-1/2 in. long bolts (30) through
oil pan plate (28) and into each balancer shaft (29).
Tighten bolts until they touch bottom of holes of bal-
28
ancer shafts, then loosen 1/2 turn.
29
30
397-1334
CAUTION
Mark on gear must be in alignment with mark on other gear.
18.
Position elbow with scavenger tube (19) as an assembly.
19.
Loosely install two washers (2), bolts (3), locks (9), and bolts (8).
20.
Position new gasket (7) between elbow with tube (19) and oil pump (12).
21.
Loosely install bolts (4 and 5).
22.
Tighten two bolts (3) and bolts (8) evenly. Bend lock (9) tabs up, toward front of engine, against bolt heads.
23.
Tighten bolts (4 and 5) evenly.
1
12
2
3
9
8
7
4
6
5
19
397-1331
24.
Remove two 3/8-16NC 1-1/2 in. long bolts (30) from oil pan plate (28) and balancer shafts (29).
25.
Install oil pan (WP 0275 00).
END OF WORK PACKAGE
0276 00-4