TM 5-3805-261-23-1
BLADE (MOLDBOARD) ASSEMBLY REPLACEMENT - CONTINUED
0259 00
REMOVAL - CONTINUED
3.
Start engine (TM 5-3805-261-10).
4.
Operate blade sideshift control to retract cylinder rod into cylinder as far as possible.
5.
Remove two nuts (13), washers (14), bolts (5), and clamps (15).
6.
Remove two bolts (12), washers (10 and 11), and spacers (9).
7.
Remove two bolts (16) and washers (17).
8.
Remove guards (4 and 6), two washers (7), and spacers (8).
4
5
6
8
7
17
16
15
14
13
9
10
12 11
397-1613
9.
Position wood blocks between blade bracket (18) and end of cylinder rod (19).
10.
Operate blade sideshift control and expand cylinder rod (19) to push blade assembly (2) away from circle (20) until two
link brackets can be installed.
WARNING
Use grade 8 3/4-in. bolts and nuts to attach link brackets. Tighten nuts to 265 lb-ft (359 Nm). Failure to fol-
low this warning may cause injury or death to personnel.
11.
Install two link brackets on blade assembly (2).
0259 00-2
