TM 5-3805-261-23-1
MISCELLANEOUS TROUBLESHOOTING PROCEDURES
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
1.
Check for proper tire inflation (TM
Inflate tires to correct pressure (TM 5-
1.
Tires Wear Unevenly.
5-3805-261-10).
3805-261-10). If the problem still exists,
go to Test 2.
2.
Check lugnuts (TM 5-3805-261-10).
Tighten lugnuts (TM 5-3805-261-10).
1.
Check ROPS mounting hardware.
Tighten bolts as necessary (WP 0327 00).
2.
ROPS Is Not Secure.
If the problem still exists, go to Test 2.
2.
Check strips on bottom of ROPS
If strips are not sealed or if they are
assembly.
damaged or defective, replace (WP 0185
1.
Check window seals (WP 0186 00
If seals are damaged or defective, replace
3.
Window Seals Are Defective
and WP 0187 00).
(CCE Machine).
problem still exists, go to Test 2.
2.
Check windows (WP 0186 00) and
If window is cracked or broken, replace
1.
Check for bends or dents in door
If door is damaged or defective, replace
4.
Door Will Not Close or Catch
assembly (WP 0188 00).
(CCE Machine).
go to Test 2.
2.
Check hinges and springs (WP 0188
If hinges and springs are damaged or
defective, replace (WP 0188 00).
Check for bent steps.
1.
If steps are bent, replace (WP 0177
5.
Steps Bent (Old Design).
2.
To prevent the problem, paint a
"danger zone" on the circle reverse as
follows: Raise and rotate blade so it
is set for travel. Stop blade when it is
a few inches from stop. Paint a black
stripe on circle reverse and another
on the circle frame just above and
back about 8 in. (20 cm). Repeat for
other side.
3.
Another method to prevent the
problem is to move the lower wire
rope to rear holes.
