TM 5-3805-261-20
HYDRAULIC SYSTEM MAINTENANCE. (cont.)
15-11.
Blade Tip Check and Relief Valve. (Sheet 2 of 4)
REMOVAL
1.
Remove nine bolts (1), washers (2 and 3)
and frame cover (4, Figure 15-14) in front,
right side of front frame.
NOTE
All hose and tube assemblies must be
tagged before disconnecting to aid in
installation. Cap all hose and tube
ends to prevent contamination.
2.
Disconnect hose assemblies (5 and 6) from
top valve ports.
3.
Remove elbow (7) and preformed packing
(8). Discard preformed packing (8).
4.
Remove elbow (9) and preformed packing
(10). Discard preformed packing (10).
5.
Disconnect hose assemblies (11 and 12,
Figure 15-15) from bottom valve ports.
6.
Remove connector (13) and preformed
packing (14).Discard preformed packing
(14).
7.
Remove connector (15) and preformed
packing (16). Discard preformed packing
(16).
8.
Remove bolt (17), washer (18) and valve
assembly (19).
CLEANING
Clean all parts. Refer to Chapter 2.
Figure 15-14.
Figure 15-15.
Go to Sheet 3
15-34
