INSTALLATION (cont) - TM-5-3805-261-20

TM-5-3805-261-20 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
929

TM 5-3805-261-20 HYDRAULIC SYSTEM MAINTENANCE. (cont) 15-9. Leaning Wheel Check Valve. (Sheet 4 of 4) INSTALLATION (cont) 5. Install new preformed packing (10) and elbow (9, Figure 15-10). 6. Install new preformed packing (8) and elbow (7). 7. Connect hose assemblies (6 and 5). WARNING Only a qualified operator may perform the next procedure. All other personnel must clear the immediate area. Failure to follow this procedure may cause INJURY. If you are injured, seek medical aid immediately. 8. Start engine. Refer to TM 5-3805-261-10. 9. Operate leaning wheel control lever. Move system through at least five full movements of travel to bleed air from system. 10. Stop engine. 11. Inspect hose assemblies and connections for leaks. 12. Refill hydraulic tank to proper level. Refer to LO 5-3805-261-12. 13. Install frame cover (4), nine washers (3 and 2) and bolts (1) in front, right side of frame. NOTE Return 130CG Grader to original equipment condition. Figure 15-10. End of Task 15-28

Privacy Statement
Press Release
Contact