TM 5-3805-261-20
BODY, CHASSIS AND HULL ACCESSORY ITEMS MAINTENANCE. (cont)
14-5.
Front Wiper (Upper). (Sheet 5 of 5)
INSTALLATION
1.
Position items 30 thru 18 as an assembly
and plate (17, Figure 14-8) in upper storage
compartments in interior of cab.
2.
Connect three wire assemblies (16) at
terminals to motor (30).
NOTE
Step 3 requires two mechanics.
3.
One mechanic installs two lockwashers (15)
and bolts (14) in upper front, exterior of cab
while the other mechanic holds items 30
thru 18 as an assembly (Figure 14-7) in cab
interior.
4.
Install new gasket (13), washer (12), snap
ring (11), nut (10), cap (9) and driver (8).
Tighten nut (10) to 15 ft-lb torque.
5.
Install clip (6), blade assembly (5), screw
(4) and lock nut (3) on arm assembly (7).
6.
Install items 7 thru 3 as an assembly
(Figure 14-6) in same position as when
removed.
7.
Install lockwasher (2) and nut (1). Tighten
nut (1) to 12 ft-lb torque.
NOTE
Return
130G
Grader
to
original
equipment condition.
Figure 14-8.
Figure 14-7.
Figure 14-6.
End of Task
14-18
