TM 5-3805-261-20
BODY, CHASSIS AND HULL ACCESSORY ITEMS MAINTENANCE.
14-5.
Front Wiper (Upper). (Sheet 2 of 5)
REMOVAL
1.
Remove nut (1) and lockwasher (2, Figure
14-6) from upper wiper assembly in exterior
of cab.
2.
Remove items 3 thru 7 as an assembly.
Push in on hinged part of arm assembly (7)
to straighten items 3 thru 7 as an assembly
and pull from shaft assembly (22). Note
position of items 3 thru 7 as an assembly on
arm assembly (7).
3.
Remove lock nut (3), screw (4), blade
assembly (5) and
clip
(6)
from
arm
assembly (7, Figure 14-7).
4.
Remove driver (8), cap (9), nut (10),snap
ring(1l)
washer(12)
and
gasket
(13).
Discard gasket (13). Remove all gasket
material from mounting surfaces.
5.
Remove two bolts (14) and lockwashers
(15).
6.
Open
center
door
in
upper
storage
compartment in interior of cab (Figure 14-
8).
NOTE
All
wire,
cable
and
harness
assemblies must be tagged before
disconnecting to aid in installation.
7.
Disconnect three wire assemblies (16) at
terminals.
8.
Remove plate (17) and items 18 thru 30 as
an assembly.
Figure 14-6.
Figure 14-7.
Figure 14-8.
14-15
