TM 5-3805-261-20
BODY, CHASSIS AND HULL ACCESSORY ITEMS MAINTENANCE. (cont)
14-4.
Front Wiper (Lower). (Sheet 6 of 7)
INSTALLATION (cont)
6.
Install new gasket (31), flange (30), four
lockwashers (29) and screws (28, Figure
14-4).
7.
Position washer (27) and shaft of wiper
motor (26) on arm (45).
8.
Install washer (27) and wiper motor (26).
9.
Connect three wire assemblies (25) at
terminals.
10.
Install cover (24) and four screws (23) in
front of steering column in interior of cab.
11.
Connect ground cables in batteries. Refer
to paragraph 7-112.
NOTE
Turn
wiper
switch
on.
Turn
disconnect switch on and off as
needed to stop motor so that flat
surfaces at sides of threaded motor
shaft align with mounting hole in arm.
Figure 14-4.
Go to Sheet 7
14-12
