REMOVAL - TM-5-3805-261-20

TM-5-3805-261-20 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
855

TM 5-3805-261-20 BODY, CHASSIS AND HULL ACCESSORY ITEMS MAINTENANCE. (cont) 14-4. Front Wiper (Lower). (Sheet 2 of 7) REMOVAL 1. Remove two nuts (1) and lock-washers (2, Figure 14-2) from lower wiper assembly on exterior of cab. 2. Remove items 3 thru 7 as an assembly. Push in on hinged part to straighten items 3 thru 7 as an assembly and pull from two linkage (34) shafts. Note position of items 3 thru 7 as an assembly. 3. Remove two lock nuts (3), screws (4), blades (5) and clips (6) from arm assembly (7, Figure 14-3). 4. Remove two drivers (8), caps (9), nuts (10), washers (11), snap rings (12), flat washers (13), spring washers (14) and gaskets (15) from linkage (34) shafts. Discard two gaskets (15) and spring washers (14). Remove all gasket material from mounting surfaces. 5. Remove four screws (16), cover (17) and gasket (18). Discard gasket (18). Remove all gasket material from mounting surfaces. NOTE Turn wiper switch on. Turn disconnect switch on and off as needed to expose three motor mounting bolts and linkage mounting nut. 6. Remove three bolts (19) and lockwashers (20). 7. Remove nut (21) and lockwasher (22). Figure 14-3. Go to Sheet 3 Figure 14-2. 14-8

Privacy Statement
Press Release
Contact