REMOVAL - TM-5-3805-261-20

Right Hand and Left Hand Blade Float Harnesses.

TM-5-3805-261-20 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
617

TM 5-3805-261-20 WIRING HARNESS MAINTENANCE. (cont) 7-135. Right Hand and Left Hand Blade Float Harnesses. (Sheet 2 of 3) REMOVAL NOTE The following is a maintenance procedure for the right blade float harness. The maintenance procedure for the left blade float harness is identical. 1. Remove two screws (1), cover (2) and gasket (3, Figure 7-222). Discard gasket (3) from blade float limit switch in cab. Remove all gasket material from mounting surfaces. 2. Loosen two screws (7, Figure 7-223). Do not remove. NOTE All wire, cable and harness assemblies must be tagged before disconnecting to aid in installation. 3. Disconnect blade float harness (6) from two screws (7). 4. Detach clip (4) from blade float harness (6) and main harness. 5. Disconnect blade float harness (6) from main harness. 6. Remove clip (4) and grommet (5) from blade float harness (6). 7. Remove blade float harness (6). Figure 7-222 Figure 7-223 Go to Sheet 3 7-354

Privacy Statement
Press Release
Contact