TM 5-3805-261-20
WIRING HARNESS MAINTENANCE.
7-135.
Right Hand and Left Hand Blade Float
Harnesses. (Sheet 3 of 3)
CLEANING
Clean all parts. Refer to Chapter 2.
INSPECTION
Inspect all parts. Refer to Chapter 2.
INSTALLATION
1.
Install blade float harness (6, Figure 7-223).
2.
Install grommet (5) and clip (4) on blade
float harness (6).
3.
Connect blade float harness (6) to main
harness under cab.
4.
Connect blade float harness (6) to two
screws (7).
5.
Tighten two screws (7).
6.
Install new gasket (3), cover (2) and two
screws (1, Figure 7-222) on blade float limit
switch.
NOTE
Return
130C
Grader
to
original
equipment condition.
End of Task
7-355
