TM 5-3805-261-20
WIRING HARNESS MAINTENANCE.
7-128.
Rear Floodlight lad. (Sheet 2 of 3)
REMOVAL
1.
Open left side screen door. Refer to paragraph
6-49, steps 1 and 2.
2.
Remove screw (1) and two lockwashers (2,
Figure 7-210) from rear of floodlight.
NOTE
All wire, cable and harness assemblies
must be tagged before disconnecting to
aid in installation.
3.
Disconnect wire assembly (8) from floodlight.
4.
Cut and discard tie strap (3) from rear, left side
of engine compartment near radiator.
5.
Disconnect wire assembly connector (4) from
main harness connector (5).
6.
Remove four bolts (6) and washers (7, Figure 7-
211).
7.
Remove wire assembly (8) from vehicle. Snake
down through grommet (10).
8.
Remove four clips (9) from wire assembly (8).
9.
Remove grommet (10).
CLEANING
Clean all parts. Refer to Chapter 2.
INSPECTION
Inspect all parts. Refer to Chapter 2.
7-210
Figure 7-211
Go to Sheet 3
7-333
