TM 5-3805-261-20
WIRING HARNESS MAINTENANCE. (cont)
7-127.
Front Floodlight Lead. (Sheet 2 of 3)
REMOVAL
1.
Loosen bolt on bottom of floodlight and
adjust floodlight forward for access to screw
(1).
2.
Remove screw (1) and lockwasher (2,
Figure 7-209) to right side of cab exterior.
NOTE
All
wire,
cable
and
harness
assemblies must be tagged before
disconnecting to aid in installation.
3.
Disconnect wire assembly (11) from right
floodlight (3).
4.
Remove bolt (4) from clip (12).
5.
Adjust lamp forward for access to screw (1).
6.
Remove screw (5) and lockwasher (6) from
left side of cab exterior.
7.
Disconnect wire assembly (11) from left
floodlight (7).
8.
Remove bolt (8) from clip (13).
9.
Detach clip (14) from wire assembly (11) at
connector (9) and main harness connector
(10) from under left side of cab.
10.
Disconnect wire assembly (11) at connector
(9) from main harness connector (10).
11.
Remove wire assembly (11) from vehicle.
12.
Remove clips (12 and 13) from wire
assembly (11).
CLEANING
Clean all parts. Refer to Chapter 2.
Figure 7-209
Go to Sheet 3
7-330
