TM 5-3805-261-20
WIRING HARNESS MAINTENANCE. (cont.)
7-121.
Electrical Monitoring System Jumper Wire.
(Sheet 2 of 2)
REMOVAL
1.
Open right side screen door. Refer to
paragraph 6-49, steps 1 and 2.
NOTE
All
wire,
cable
and
harness
assemblies must be tagged before
disconnecting to aid in installation.
2.
Detach jumper wire assembly and harness
assembly at connector from clip on fuel
tank (Figure 7-203).
3.
Disconnect jumper wire assembly and
harness assembly at connector.
CLEANING
Clean all parts. Refer to Chapter 2.
INSPECTION
Inspect all parts. Refer to Chapter 2.
INSTALLATION
1.
Connect harness assembly at connector
and jumper wire assembly (Figure 7-203).
2.
Attach harness assembly at connector and
jumper wire assembly to clip on fuel tank.
3.
Close right side screen door. Refer to
paragraph 6-49, steps 4 thru 7.
NOTE
Return
130G
Grader
to
original
equipment condition.
Figure 7-203
End of Task
7-316
