TM 5-3805-261-20
HORN AND BACK-UP ALARM MAINTENANCE.
7-103.
Horn Switch. (Sheet 3 of 3)
INSPECTION
Inspect all parts. Refer to Chapter 2.
INSTALLATION
1.
Install retainer (18) and bracket (17,
Figure 7-155) on steering wheel console.
2.
Install new seal (16).
3.
Position wire assembly (15).
4.
Connect
wire
harness
(14)
to
wire
assembly
(15,
Figure
7-154)
at
connectors.
5.
Install four springs (13) and brushes (12).
6.
Install ring (11) and insulator (10).
7.
Install steering wheel (9, Figure 7-153).
8.
Install nut (8). Tighten nut (8) to 44 ft-lb
torque.
9.
Install three pins (7).
10.
Install spring (6) and button (5).
11.
Install horn film (4).
12.
Position new gasket (3) and retainer (2).
13.
Install three screws (1).
NOTE
Return 130C Grader to original
equipment condition.
End of Task
7-251
