TM 5-3805-261-20
HORN AND BACK-UP ALARM MAINTENANCE. (cont)
7-103.
Horn Switch. (Sheet 2 of 3)
REMOVAL
1.
Remove three screws (1), retainer (2)
and gasket (3) from steering wheel (9,
Figure 7-153). Discard gasket (3). Remove
all gasket material from mounting surfaces.
2.
Remove horn film (4), button (5) and spring
(6).
3.
Remove three pins (7).
4.
Remove nut (8).
5.
Using steering wheel puller, remove steering
wheel (9).
6.
Remove insulator (10) and ring (11, 7-154).
7.
Remove four brushes (12) and springs (13).
NOTE
All wire, cable and harness assemblies
must be tagged before disconnecting
to aid in installation.
8.
Disconnect wire harness (14) from wire
assembly (15) at connectors.
9.
Remove wire assembly (15, Figure 7-155).
10.
Remove and discard seal (16).
11.
Remove bracket (17) and retainer (18).
CLEANING
Clean all parts. Refer to Chapter 2.
Figure 7-153
Figure 7-154
Figure 7-155
Go to Sheet 3
7-250