TM 5-3805-261-20
HORN AND BACK-UP ALARM MAINTENANCE. (cont)
7-102.
Horn. (Sheet 2 of 2)
REMOVAL
NOTE
All
wire,
cable
and
harness
assemblies must be tagged before
disconnecting to aid in installation.
1.
Disconnect wire assembly (1, Figure 7-152)
at two terminals from under front, left side
of cab.
2.
Remove two bolts (2) and washers (3).
3.
Remove horn (4).
CLEANING
Clean all parts. Refer to Chapter 2.
INSPECTION
Inspect all parts. Refer to Chapter 2.
INSTALLATION
1.
Position horn (4, Figure 7-152).
2
Install two washers (3) and bolts (2).
3.
Connect wire assembly (1) at two terminals.
NOTE
Return
130G
Grader
to
original
equipment condition.
Figure 7-152
End of Task
7-248
