TM 5-3805-261-20COOLING SYSTEM MAINTENANCE. (cont)6-46.FanandFanDrive.(Sheet 4 of 7)REMOVAL (cont)23.Remove pulley (20) from shaft (26, Figure6-115).24.Remove spacers (21 and 22).25.Using a suitable driver and hammer,remove seal (23) and bearing (24). Discardseal (23).26.Using a hammer and punch, remove anddiscard pin (25).27.Remove shaft (26) from bracket (27).CLEANINGClean all parts. Refer to Chapter 2.INSPECTIONInspect all parts. Refer to Chapter 2.INSTALLATION1.Install shaft (26) in bracket (27). Align pin(25) hole in shaft (26) with hole in bracket(27, Figure 6-116).2.Using a hammer and punch install new pin(25).3.Using a suitable driver and hammer, installnew seal (23). Drive new seal in flush withsmall end of hub (19). Lip of new seal (23)must face outward.Figure 6-115.Figure 6-116.Go to Sheet 56-164
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
