TM 5-3805-261-20 COOLING SYSTEM MAINTENANCE. 6-46. Fan and Fan Drive.  (Sheet 1 of 7) This task covers: a. Removal b. Cleaning c. Inspection d. Installation INITIAL SETUP: Applicable Configurations Personnel Required A11 Two construction equipment repairers MOS 62B Tools General Mechanic’s Tool Kit: References Automotive (NSN 5180-00-177- TM 5-3805-261-10 7033) LO 5-3805-261-12 Gun, grease Puller, Jaw type, four inch Special Environmental Conditions None Test Equipment None General Safety Instructions None Materials/Parts Dry cleaning solvent, Torques Item 14, Appendix C All fasteners are tightened to Clean cloths, Item 39, standard torques.  Refer to Appendix C Appendix E. Detergent, Item 8, Appendix C Multi-purpose grease, Item 20 Appendix C Preformed packing, Item 17 Seal, Item 23 Pin, Item 25 Troubleshooting References None Equipment Condition TM 5-3805-261-10 Vehicle parked on level ground. Parking/emergency brake applied. Equipment lowered to the ground. Engine stopped. Master disconnect switch off. Paragraph 6-44 Fan belts removed. Paragraph 6-45 Fan drive lubrication line removed. Go to Sheet 2 Change 1   6-161