TM 5-3805-261-20
COOLING SYSTEM MAINTENANCE. (cont)
6-44.
Fan Belts. (Sheet 2 of 3)
REMOVAL
1.
Open left side screen door. Refer to
paragraph 6-49, steps 1 and 2.
2.
Loosen three bolts (6, 7 and 8, Figure 6-
109).
3.
Push in alternator (1) on bracket (2) to
relieve belt tension.
4.
Remove two belts (3) from pulleys (4 and
5). Discard two belts (3) if cracked, worn,
broken, frayed or oil soaked.
CLEANING
Clean all parts. Refer to Chapter 2.
INSPECTION
Inspect all parts. Refer to Chapter 2.
INSTALLATION
CAUTION
When installing belts use care to
avoid cutting belts on fan blades.
NOTE
Belts must be replaced as a matched
set.
1.
Install two new belts (3) on pulleys (4 and 5,
Figure 6-109), if necessary.
2.
Pull out alternator (1) on bracket (2) until
two belts (3) are tight.
3.
Hand tighten three bolts (8, 7 and 6).
4.
Close left side screen door. Refer to
paragraph 6-49, steps 4 thru 7.
Figure 6-109.
Go to Sheet 3
6-156