TM 5-3805-261-20 FUEL SYSTEM MAINTENANCE.  (cont.) 6-20. Turbocharger.  (Sheet 1 of 3) This task covers: a. Removal b. Cleaning c. Inspection d. Installation INITIAL SETUP Applicable Configurations Personnel Required All Construction equipment repairer MOS 62B Tools General Mechanic’s Tool Kit: References Automotive (NSN 5180-00-177- TM 5-3805-261-10 7033) Torch Special Environmental Conditions None Test Equipment None General Safety Instructions None Materials/Parts Dry cleaning solvent, Torques Item 14, Appendix C Except for special torques shown, Clean cloths, Item 39, all fasteners are tightened to Appendix C standard torques.  Refer to Small tags, Item 41, Appendix C Appendix E. Detergent, Item 8, Appendix C Anti-seize compound, Item 59, Appendix C Gasket, Item 6 Caps Plugs Troubleshooting References None Equipment Condition TM 5-3805-261-10 Vehicle parked on level ground. Parking/emergency brake applied. Equipment lowered to the ground. Engine stopped. Master disconnect switch off. Paragraph 6-10 Turbocharger oil lines removed. Paragraph 6-19 Turbocharger air lines removed. Paragraph 6-21 Turbocharger exhaust elbow removed. Paragraph 13-5 Engine compartment side panels and doors removed. Go to Sheet 2 6-70