REMOVAL - TM-5-3805-261-20

TM-5-3805-261-20 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
124

TM 5-3805-261-20 ENGINE MAINTENANCE. (cont) 6-10. Turbocharger Oil Lines. (Sheet 2 of 4) REMOVAL 1. Remove two nuts (1), four washers (2), two bolts (3) and four clips (4, Figure 6-22) from right side of engine. 2. Remove bolts (5 and 6) from top of turbocharger. NOTE All hose and tube assemblies must be tagged before disconnecting to aid in installation. Cap all hose and tube ends and plug all open oil ports to prevent contamination. 3. Disconnect tube assembly (7) nut from connector (11, Figure 6-23) under injection pump support. 4. Remove cotter pin (8) and pin (9) from throttle linkage. 5. Remove tube assembly (7) and gasket (10) from vehicle. Discard gasket (10) and remove all gasket material from mounting surfaces. 6. Remove connector (11) and pre- formed packing (12) from injection pump support. Discard preformed packing (12). 7. Remove two bolts (13, Figure 6-24) from under turbocharger. NOTE Remove items 14 thru 19 as an assembly then disassemble. Figure 6-24. Go to Sheet 3 Figure 6-23. Figure 6-22. 6-32

Privacy Statement
Press Release
Contact