REMOVAL (cont)]

TM-5-3805-261-20 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
113

TM 5-3805-261-20 ENGINE MAINTENANCE. 6-6. Oil Level Gage. (Sheet 3 of 3) REMOVAL (cont) 10. Remove connector (10) from cylinder block. CLEANING Clean all parts. Refer to Chapter 2. INSPECTION Inspect all parts. Refer to Chapter 2. INSTALLATION 1. Install connector (10, Figure 6-13) in cylinder block on lower left side of engine. 2. If removed, install sleeve (9) and nut (8) on tube assembly (7). 3. Position tube assembly (7) on left side of engine. 4. Install bolt (4, Figure 6-12). 5. Tighten nut (8). 6. Install bolt (6) that secures hose. 7. Connect air line (5). 8. Install two elbows (3). 9. Install tube assembly (2, Figure 6-11). 10. Install oil level gage (1). NOTE Return 130G Grader to original condition. 11. Install oil level gage (1). 12. Check tube assemblies (2 and 7) in lower left side of engine for leaks. 13. Stop engine. End of Task 6-21

Privacy Statement
Press Release
Contact