Oil Level Gage

TM-5-3805-261-20 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
112

TM 5-3805-261-20 ENGINE MAINTENANCE. (cont) 6-6. Oil Level Gage. (Sheet 2 of 3) REMOVAL 1. Pull out oil level gage (1, Figure 6-11) from left side of engine. NOTE All hose and tube assemblies must be tagged before disconnecting to aid in installation. Cap all hose and tube ends to prevent contamination. 2. Loosen two nuts on tube assembly (2) in lower left side of engine and remove. 3. Remove two elbows (3, Figure 6-12). 4. Remove bolt (4). WARNING Air tank is under high pressure and must be drained. Failure to do so can result in INJURY OR BLINDNESS from flying particles. 5. Disconnect air line (5). 6. Remove bolt (6) securing clamp on air line (5). 7. Loosen nut (8, Figure 6-13). 8. Remove tube assembly (7). NOTE Remove nut and sleeve only if inspection indicates leakage around sleeve. 9. Remove nut (8) and cut and discard sleeve (9). Cut damaged sleeve (9) from tube assembly (7). Figure 6-11. Figure 6-12. Figure 6-13. Go to Sheet 3 6-20

Privacy Statement
Press Release
Contact