TM 5-3805-261-20
ENGINE MAINTENANCE. (cont)
6-5.
Oil Filter. (Sheet 2 of 2)
REMOVAL
1.
Open left side engine door.
WARNING
Exercise care when working with hot
oil or components saturated with hot
oil. Allow to cool
before
handling.
Injury may result if you fail to follow
this procedure.
2.
Remove and discard oil filter from left
side of engine. Remove old oil filter
seal from oil filter base (Figure 6-9).
INSTALLATION
1.
Using clean engine oil, lubricate new
oil filter seal.
2.
Install new oil filter (Figure 6-9). Hand
tighten oil filter an additional 3/4 turn
after new oil filter seal makes contact
with oil filter base (Figure 6-10).
3.
Refill engine oil to proper level. Refer
to LO 5-3805-261-12.
4.
Turn Master disconnect switch on and
start engine. Refer to TM 5-3805-261-
10.
5.
Check oil filter for leaks. Stop engine.
If leakage is evident, tighten filter.
6.
Close left side engine door.
NOTE
Return
130G
Grader
to
original
equipment condition.
Figure 6-9.
Figure 6-10.
End of Task
6-18
