INSTALLATION - TM-5-3805-261-20

TM-5-3805-261-20 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
1032

TM 5-3805-261-20 HYDRAULIC SYSTEM MAINTENANCE. (cont) 15-27. Circle Drive Motor Hoses and Fittings. (Sheet 6 of 6) INSTALLATION (cont) 10. Install two clamps (11), plates (10), washers (9) and bolts (8, Figure 15-114). 11. Install clamp (7), washer (6) and bolt (5, Figure 15-113). 12. Install new preformed packing (4), connector (3), new preformed packing (2) and connector (1,Figure 15-112). 13. Connect hose assemblies (13 and 12). WARNING Only a qualified operator may perform the next procedure. All other personnel must clear the immediate area. Failure to follow this procedure may cause INJURY. If you are injured, seek medical aid immediately. 14. Start engine. Refer to TM 5-3805-261-10. 15. Operate circle drive motor control. Move system through at least five full movements of travel to bleed air from system. 16 Stop engine. 17. Inspect hose assemblies and connections for leaks. 18. Refill hydraulic tank to proper level. Refer to LO 5-3805-261-12. NOTE Return 130G Grader to original equipment condition. Figure 15-114. Figure 15-113. Figure 15-112. End of Task 15-148

Privacy Statement
Press Release
Contact