REMOVAL (cont) - TM-5-3805-261-20

TM-5-3805-261-20 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
1030

TM 5-3805-261-20 HYDRAULIC SYSTEM MAINTENANCE. 15-27. Circle Drive Motor Hoses and Fittings. (Sheet 4 of 6) REMOVAL (cont) 10. Remove two bolts (25), washers (26), clamps (27) and spacers (28, Figure 15- 118). 11. Disconnect two hose assemblies. Refer to paragraph 15-25, steps 1 and 2. 12. Remove hose assemblies (29 and 30, Figure 15-119) from left control valve group. 13. Remove two elbows (31) and preformed packings (32, Figure 15-120). Discard preformed packings (32). CLEANING Clean all parts. Refer to Chapter 2. INSPECTION Inspect all parts. Refer to Chapter 2. INSTALLATION 1. Install two new preformed packings (32) and elbows (31, Figure 15-120) to left control valve group. 2. Install hose assemblies (30 and 29, Figure 15-119) on left control valve group. 3. Connect two hose assemblies. Refer to paragraph 15-25, steps 24 and 25. 4. Install two spacers (28), clamps (27), washers (26) and bolts (25, Figure 15-118). Figure 15-118. Figure 15-119. Figure 15-120. Go to Sheet 5 15-146

Privacy Statement
Press Release
Contact