TM 5-3805-261-20
HYDRAULIC SYSTEM MAINTENANCE. (cont)
15-26.
Leaning Wheel Hoses and Fittings. (Sheet 7 of 7)
INSTALLATION
12.
Install
new
preformed
packing
(4),
connector (3), new preformed packing (2)
and connector (1, Figure 15-106).
13.
Connect hoses (20 and 19) to right control
valve group.
14.
Connect four hose assemblies. Refer to
paragraph 15-32, steps 11 and 10 and
paragraph 15-24, steps 29 and 30.
WARNING
Only
a
qualified
operator
may
perform the next procedure. All other
personnel must clear the immediate
area. Failure to follow this procedure
may cause INJURY. If you are
injured,
seek
medical
aid
immediately.
15.
Start engine. Refer to TM 5- 3805-261-10.
16.
Operate scarifier control lever. Move
system through at least five full movements
of travel to bleed air from the system.
17.
Stop engine.
18.
Inspect all hoses and connections for leaks.
19.
Refill hydraulic tank to proper level. Refer
to LO 5-3805-261-12.
NOTE
Return
130G
Grader
to
original
equipment condition.
Figure 15-106.
End of Task
15-142