TM 5-3805-261-10
SECTIONALIZATION FOR AIR TRANSPORT - CONTINUED
0019 00
ASSEMBLY - CONTINUED
Engage the parking/emergency brake, shift the transmission to Neutral and disengage the clutch. See Driving the Rear
8.
Frame in this work package.
9.
Start the engine and move the rear frame to within 3 ft. (1 m) of the front frame, aligning the articulation joint as close as
possible. See Driving the Rear Frame in this work package.
10.
Disengage the clutch, set the parking/emergency brake, shut down the engine, and shift the transmission to Neutral.
11.
Position two screw jacks (63) over mounting holes on each side of rear frame and tandem housing.
12.
Install two pins (64) and spring clips (65) through mounting holes of each screw jack (63).
13.
Adjust screw jacks (63) as needed to remove load from tandem links.
14.
Remove two bolts (79), washers (80), and cap (81) from each tandem link.
15.
Remove two tandem links from frame and store links in the tool box.
16.
Reinstall two bolts (79), washers (80), and cap (81) in each tandem link mount.
64
65
TANDEM LINK
63
79,80
397-1109
81
17.
Remove straps (Item 20, Table 1, WP 0021 00) secur-
ing articulation cylinders, cables, and hoses.
6
LOCK BAR
18.
Remove straps (Item 19, Table 1, WP 0021 00) secur-
ing lower pivot pin bushing.
19.
Pull the articulation cylinders away from the frame.
20.
Install lock bar and two bolts (6) on pump shaft yoke
on front section.
397-1108
0019 00-24
