TM 5-3805-261-10
SECTIONALIZATION FOR AIR TRANSPORT - CONTINUED
0019 00
DISASSEMBLY - CONTINUED
82.
Install two bolts (70) and nuts (71) on remote control
70,71
box (72).
83.
control box hoses and cables.
72
84.
Store the articulation cylinder pins, pump driveshaft,
driveshaft guard, screw jacks, tools, jumpers, and all
other loose parts in the tool box on the front frame.
Secure toolbox lid. Refer to the tool box inventory list
and ensure that all parts are accounted for.
85.
Cover the pivot pins and pivot pin bores with plastic
or other material to prevent foreign matter from accu-
397-1083
70,71
mulating on the machined surfaces. Secure the cover-
ing with tape.
DRIVING THE REAR FRAME
WARNING
Wear hearing protection while operating the rear section of the grader. Failure to follow this warning may
result in hearing loss.
NOTE
Remote control operation can be accomplished by one person. Use a ground guide to aid in starting and
aligning the frames for reassembly.
The backup alarm should sound when the transmission direction lever is placed in reverse (R).
ETHER STARTING
1.
Turn the battery disconnect switch on.
AID
2.
Move the throttle to the low idle position.
ENGINE
3.
Press the start button to start the engine. The ether
START
starting aid may be required in cold weather condi-
BUTTON
BATTERY
DISCONNECT
SWITCH
397-1088
0019 00-20