TM 5-3805-261-10
SECTIONALIZATION FOR AIR TRANSPORT - CONTINUED
0019 00
DRIVING THE REAR FRAME - CONTINUED
5.
Turning the machine:
NOTE
The directions LEFT and RIGHT in this procedure relate to the direction of travel.
a.
While moving the machine in a forward direction, pull the steering control toward you to turn the machine toward
you (LEFT TURN). Push the steering control away from you to turn the machine away from you (RIGHT TURN).
b.
While moving the machine in reverse, the steering control is reversed. Pull the steering control toward you to turn
the machine toward you (RIGHT TURN). Push the steering control away from you to turn the machine away from
you (LEFT TURN).
NOTE
Additional clutch engagement may be required to slide the wheels when turning, depending on ground con-
ditions.
6.
Stopping the machine:
a.
Apply service brakes by releasing button on STEERING control.
b.
Carefully disengage clutch by rotating CLUTCH control to the left.
c.
Turn on the parking/emergency brake by pulling out the PARKING BRAKE control.
d.
Shift transmission into Neutral by pulling GEAR SELECTION control fully out.
e.
Shut down engine by raising throttle lever to NO FUEL position.
f.
Turn off the battery disconnect switch.
ASSEMBLY
NOTE
Assembly must be performed on a firm, level surface.
All sectionalized components and tools are located in tool box on front section of machine.
The pivot pins, bolts, and clamps are installed on the frame sections.
Remove plastic covering on pivot pins from machine.
1.
Remove two nuts (70) and bolts (71) from remote con-
70,71
trol box (72).
72
WARNING
Use extreme caution when handling heavy
parts. Provide adequate support and use
assistance during procedure. Failure to fol-
low this warning may result in injury to
personnel.
NOTE
397-1083
70,71
Remote control box weighs 68 lb (31 kg).
2.
With assistance, remove remote control box (72) from
machine.
0019 00-22