TM 5-3805-261-10
SECTIONALIZATION FOR AIR TRANSPORT - CONTINUED
0019 00
DISASSEMBLY - CONTINUED
NOTE
To aid in clutch cable connection, press button on remote control box clutch control to allow cable to move
freely.
59.
Connect remote control cables to machine cables (use tags added during removal).
Turn on battery disconnect switch and start engine. See Driving the Rear Frame in this work package.
60.
WARNING
Keep all personnel away from machine when separating front and rear sections. The front section may drop
a few inches if there is not enough blade down pressure.
61.
Apply a slight amount of blade down pressure.
62.
Drive rear frame very slowly about 3 ft. away from front section. Guide jumper hoses carefully to prevent damage. See
Driving the Rear Frame in this work package.
63.
Disconnect electrical jumper cable and two jumper hoses connecting the front and rear sections.
64.
Install dust caps on hose ends.
65.
Install upper pivot pin (9), bolts (10), and washers (11) in front frame. Tighten bolts enough to secure pin.
66.
Install lower pivot pin (26), bolts (68), and washers (69) in rear frame. Tighten bolts enough to secure pin.
67.
Install retainer (56) and bolts (25) on lower pivot pin (26).
68,69
10,11
397-1127
26
56
25
9
(HIDDEN)
0019 00-17