Place a suitable container under
Remove
lower strainer assembly.
attaching hardware, lower strainer
Discard
cover (29) and gasket.
gasket. Approximately 1-1/2 gallons
of oil will drain from this point.
Remove strainer (30) and magnet
(31).
Dry cleaning solvent (P-D-
680) used to clean parts is
toxic and flammable.
Use
well
ventilated
only in
areas.
Wear
protective
goggles and gloves.
Do not
smoke or allow open flames
or sparks in areas where
cleaning solvent is used or
stored.
Avoid contact with
eyes, skin, and clothing l
If contact is made, flush
with cold water and seek
medical attention.
If you
become dizzy while using
cleaning solvent, get fresh
air immediately.
Compressed
air
used
for
cleaning purposes will not
exceed 30 PSI.
Use only
with effective chip guarding
and
personal
protective
equipment (goggles, shield,
gloves, etc.)
Clean strainer and magnet with SD-II.
Dry thoroughly with compressed air.
Install clean strainer and magnet.
Install new gasket, lower strainer
cover (29) and attaching hardware.
Repeat procedure for upper strainer
assembly (32).
Card 18 of 30
QUARTERLY (Cont)
LO 5 -3805-261-12
