COMPRESSED AIR HAZARD
air
used
for
Compressed
cleaning purposes will not
Use only
exceed 30 PSI.
with effective chip guarding
personal
protective
and
(goggles/shield,
equipment
gloves, etc.)
Clean all parts with SD-II. Dry thor-
oughly with compound air.
Install two new filter elements (27)
Install
and clean screen (28).
manifold (26) and attaching hard-
ware. Install filler cap (13).
Start engine and operate at low idle
Check for leaks.
to fill filters.
Stop engine and check fluid level on
sight gage (12).
If necessary, add
fluid to FULL level.
22.
TRANSMISSION AND DIFFERENTIAL
HOUSING (0)
Hot oil can cause burns and
Use care
SERIOUS INJURY.
when draining hot oil and
and
filters
changing
atrainers.
NOTE
The vehicle must be parked
on level ground with all
equipment
lowered to
the
and
off
engine
ground,
parking brake applied before
performing this procedure.
The following procedure is
strainer
lower
for
the
assembly. The procedure for
the upper strainer assembly
is identical.
LO 5-3805-261-12
QUARTERLY (Cont)
Card 17 of 30