TM 5-3805-293-23-3
0097
LOW PRESSURE SWITCH REMOVAL
00097
1. Disconnect wiring harness connector (Figure 2, Item 6) from low pressure switch connector (Figure 2, Item 5).
2. Remove low pressure switch connector (Figure 2, Item 5) from clip (Figure 2, Item 4).
3. Remove low pressure switch (Figure 2, Item 1) and O-ring (Figure 2, Item 3) from tube (Figure 2, Item 2). Dis-
card O-ring.
Figure 2. Low Pressure Switch.
0097
END OF TASK
CLEANING AND INSPECTION
00097
1. Clean and inspect all mechanical parts IAW Mechanical General Maintenance Instructions (WP 0346).
2. Clean and inspect all electrical parts IAW Electrical General Maintenance Instructions (WP 0347).
END OF TASK
LOW PRESSURE SWITCH INSTALLATION
00097
1. Install new O-ring (Figure 2, Item 3) and low pressure switch (Figure 2, Item 1) on tube (Figure 2, Item 2).
2. Install low pressure switch connector (Figure 2, Item 5) on clip (Figure 2, Item 4).
3. Connect wiring harness connector (Figure 2, Item 6) to low pressure switch connector (Figure 2, Item 5).
END OF TASK