TM 5-3805-293-23-3
0067
REMOVAL
00067
N OT E
Tag and mark wires and lines to aid in installation.
1. Record all diagnostic codes and save ECM configuration data (WP 0007).
2. Remove nut (Figure 1, Item 9), two washers (Figure 1, Item 13), clamps (Figure 1, Item 12), spacer (Figure 1,
Item 11) and bolt (Figure 1, Item 14) from clamp (Figure 1, Item 10).
3. Disconnect wiring harness connector (Figure 1, Item 5) from filter base (Figure 1, Item 8).
4. Remove two bolts (Figure 1, Item 7), spacer (Figure 1, Item 4), four washers (Figure 1, Item 6), bolt (Figure 1,
Item 1), spacer (Figure 1, Item 3), two washers (Figure 1, Item 2), filter base (Figure 1, Item 8) from hydraulic
service pack (Figure 1, Item 15).
5. Position fuel filter (Figure 1, Item 8) aside.
Figure 1. Fuel Filter.
0067