TM 5-3805-293-23-3
0064
REMOVAL CONTINUED
9. Remove three tiedown straps (Figure 2, Item 6) from FE harness (Figure 2, Item 7). Discard tiedown straps.
10. Remove FE harness (Figure 2, Item 7) from machine.
Figure 2. FE Harness: Turbocharger Inlet and Ether Aid Plugs.
0064
END OF TASK
CLEANING AND INSPECTION
00064
1. Clean and inspect all mechanical parts IAW Mechanical General Maintenance Instructions (WP 0346).
2. Clean and inspect all electrical components IAW Electrical General Maintenance Instructions (WP 0347).
END OF TASK
INSTALLATION
00064
1. Install FE harness (Figure 2, Item 7) on machine.
2. Connect turbocharger inlet pressure sensor plug (Figure 2, Item 8) to sensor connector (Figure 2, Item 9).
N OT E
If machine is equipped with an arctic heater, install additional clamp on machine.
3. Install washer (Figure 2, Item 2), bolt (Figure 2, Item 1), two clamps (Figure 2, Item 3) and spacer (Figure 2,
Item 10) on hydraulic service pack.
4. Connect ether aid solenoid plug (Figure 2, Item 5) to solenoid connector (Figure 2, Item 4).
5. Install three new tiedown straps (Figure 2, Item 6) on FE harness (Figure 2, Item 7) and secure to machine.