TM 5-3805-293-23-2
0031
Table 1. Implement Code (2200-00 TO 2954-14) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2200-04 Left Steering Cylin-
8. Using the MSD (WP 0006), select
2201-04 Code Becomes Active -
der Position Sensor Voltage
Implement 120M and check if
Disconnect UA-C2 (WP 0009, Figure
Below Normal - Continued
2201-04 becomes active.
192) from right steering position
sensor (WP 0009, Figure 197).
Disconnect UC-C2 (WP 0009, Figure
196) from left steering position sensor
(WP 0009, Figure 193).
Left steering position sensor is faulty,
replace left steering cylinder (WP
0169).
Connect the steering position sensor
harness UC-C2 (WP 0009, Figure
196) to right steering position sensor
(WP 0009, Figure 197) (WP 0169).
Proceed to step 9.
2200-04 Code Remains Active -
Proceed to Test Step 2.
9. Using the MSD (WP 0006), select 2200-04 Code Active - Repeat
Implement 120M and verify 2200- troubleshooting code from the
04 is not active.
beginning.
2200-04 Code Not Active -
Troubleshooting complete.
Test Step 2. Test for Shorted Rear
Chassis Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
2. Disconnect UA-C2 (WP 0009,
Figure 192) from right steering
position sensor (WP 0009, Figure
197).
3. Disconnect UC-C2 (WP 0009,
Figure 196) from left steering
position sensor (WP 0009, Figure
193).
4. Connect the steering position
sensor harness UC-C2 (WP
0009, Figure 196) to right steering
position sensor (WP 0009, Figure
197) (WP 0169).
0031-24