TM 5-3805-293-23-2
0031
Table 1. Implement Code (2200-00 TO 2954-14) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2200-04 Left Steering Cylin-
2. Using a digital multimeter, mea-
Continuity - Proceed to Test Step 4.
der Position Sensor Voltage
sure resistance between cab
No Continuity - Rear chassis wiring
Below Normal - Continued
lower wiring harness connector P-
harness is shorted, replace rear
C69 (WP 0009, Figure 46) termi-
chassis wiring harness (WP 0188).
nal 47 and terminal 27.
Connect the steering position sensor
There should be no continuity.
harness UA-C2 (WP 0009, Figure
192) to left steering position sensor
(WP 0009, Figure 193) (WP 0169).
Connect the cab lower wiring harness
connector P-C39 (WP 0009, Figure
70) to implement ECM J-2 (WP 0009,
Figure 71) (WP 0268).
Connect the cab lower wiring harness
connector P-C41 (WP 0009, Figure
68) to implement ECM J-1 (WP 0009,
Figure 69) (WP 0268).
Proceed to step 3.
3. Using the MSD (WP 0006), select 2200-04 Code Active - Repeat
Implement 120M and verify 2200- troubleshooting code from the
04 is not active.
beginning.
2200-04 Code Not Active -
Troubleshooting complete.
Test Step 4. Test for Shorted Front
Chassis Wiring Harness.
1. Disconnect the front chassis wir-
ing harness connector U-C36
(WP 0009, Figure 188) from cab
lower wiring harness P-C151 (WP
0009, Figure 189) (WP 0180).
2. Using a digital multimeter, mea-
Continuity - Proceed to Test Step 5.
sure resistance between front
chassis wiring harness connector
U-C36 (WP 0009, Figure 188) ter-
minal 2 and terminal 6.
There should be no continuity.
0031-26