TM 5-3805-293-23-2
0029
Table 1. Implement Code (2160-03 TO 2168-13) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2166-05 Blade Sideshift
7. Using digital multimeter, test for
Resistance 5.0 Ohms or Less -
Right Solenoid Current
continuity between harness con-
Replace implement 1 ECM (WP
Below Normal - Continued
nector P-C41 (WP 0009, Figure
0268).
68) terminal 55 and terminal 66.
Remove jumper wire from harness
Resistance should be less than
connector P-C50 (WP 0009, Figure
5.0 ohms.
120) terminal 11 and terminal 37.
Connect front attachment harness
connector U-C46 (WP 0009, Figure
248) to blade sideshift right solenoid
(WP 0009, Figure 249), and install
front frame nose cover (WP 0224).
Proceed to step 8.
Resistance More Than 5.0 Ohms -
Replace cab lower wiring harness
(WP 0266).
Connect front attachment harness
connector U-C46 (WP 0009, Figure
248) to blade sideshift right solenoid
(WP 0009, Figure 249), and install
front frame nose cover (WP 0224).
Proceed to step 8.
8. Using MSD (WP 0006), select
2166-05 Code Active - Repeat
Implement 120M and verify 2166- troubleshooting code from the
05 is active.
beginning.
2166-05 Code Not Active -
Troubleshooting complete.
0029-46
