TM 5-3805-293-23-2
0029
Table 1. Implement Code (2160-03 TO 2168-13) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2166-13 Blade Sideshift
3. Using MSD (WP 0006), select
2166-13 Code Active - Repeat
Implement 120M and verify 2166- troubleshooting code from the
bration - Continued
13 is active.
beginning.
2166-13 Code Not Active -
Troubleshooting complete.
System Response:
Voltage Above Normal
ECM will log a diagnostic code.
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a con-
nection is found, correct the problem and verify that this diagnostic code
is Active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is active.
Test Step 1. Verify if Code 2167-03
is Active.
1. Connect MSD (WP 0006). Select 2167-03 Code Active - Proceed to
Implement 120M and verify 2167- Test Step 2.
03 is active.
2167-03 Code Not Active -
Troubleshooting complete.
Test Step 2. Test Implement 2 ECM.
1. Turn ignition switch and battery
disconnect switch to the OFF
position (TM 5-3805-293-10).
2. Remove front frame nose cover
(WP 0224).
3. Disconnect front attachment har-
ness connector U-C17 (WP 0009,
Figure 254) from circle left sole-
noid (WP 0009, Figure 255).
4. Disconnect cab lower harness
connector P-C45 (WP 0009, Fig-
ure 72) from implement 2 ECM J1
(WP 0009, Figure 73) (WP 0268).
0029-50