TM 5-3805-293-23-2
0029
Table 1. Implement Code (2160-03 TO 2168-13) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2165-05 Blade Sideshift Left 7. Using digital multimeter, test for
Resistance 5.0 Ohms or Less -
Solenoid Current Below Nor-
continuity between harness con-
Replace implement 1 ECM (WP
mal - Continued
nector P-C41 (WP 0009, Figure
0268).
68) terminal 55 and terminal 65.
Remove jumper wire from harness
Resistance should be less than
connector P-C50 (WP 0009, Figure
5.0 ohms.
120) terminal 12 and terminal 37.
Connect cab lower harness connector
P-C41 (WP 0009, Figure 68) to
implement 1 ECM J1 (WP 0009,
Figure 69) (WP 0268).
Connect front attachment harness
connector U-C45 (WP 0009, Figure
250) to blade sideshift left solenoid
(WP 0009, Figure 251), and install
front frame nose cover (WP 0224).
Proceed to step 8.
Resistance More Than 5.0 Ohms -
Replace cab lower wiring harness
(WP 0266).
Connect front attachment harness
connector U-C45 (WP 0009, Figure
250) to blade sideshift left solenoid
(WP 0009, Figure 251), and install
front frame nose cover (WP 0224).
Proceed to step 8.
8. Using MSD (WP 0006), select
2165-05 Code Active - Repeat
Implement 120M and verify 2165- troubleshooting code from the
05 is active.
beginning.
2165-05 Code Not Active -
Troubleshooting complete.
0029-38