TM 5-3805-293-23-2
0029
Table 1. Implement Code (2160-03 TO 2168-13) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2165-03 Blade Sideshift Left 3. Using MSD (WP 0006), select
2165-03 Code Active - Repeat
Solenoid Voltage Above Nor-
Implement 120M and verify 2165- troubleshooting code from the
mal - Continued
03 is active.
beginning.
2165-03 Code Not Active -
Troubleshooting complete.
2165-05 Blade Sideshift Left System Response:
Solenoid Current Below Nor- ECM will log a diagnostic code.
mal
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a con-
nection is found, correct the problem and verify that this diagnostic code
is Active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is active.
Test Step 1. Verify if Code 2165-05
is Active.
1. Connect MSD (WP 0006). Select 2165-05 Code Active - Proceed to
Implement 120M and verify 2165- Test Step 2.
05 is active.
2165-05 Code Not Active -
Troubleshooting complete.
Test Step 2. Test Implement 1 ECM.
1. Turn ignition switch and battery
disconnect switch to the OFF
position (TM 5-3805-293-10).
2. Remove rear front frame cover
(WP 0224).
3. Disconnect front attachment har-
ness connector U-C45 (WP 0009,
Figure 250) from blade sideshift
left solenoid (WP 0009, Figure
251).
4. Install a jumper wire between har-
ness connector U-C45 (WP 0009,
Figure 250) terminal 1 and termi-
nal 2.
5. Turn battery disconnect switch
and ignition switch to the ON posi-
tion (TM 5-3805-293-10).
0029-36