TM 5-3805-293-23-2
0028
Table 1. Implement Code (2146-02 to 2156-08) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2150-04 Blade Left Lift Lever
System Response:
Position Sensor Voltage
ECM will log diagnostic code.
Below Normal
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a con-
nection is found, correct the problem and verify that this diagnostic code
is active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is active.
Test Step 1. Test for Active Code.
Connect the MSD (WP 0006). Select
2150-04 Code Active - Proceed to
Implement 120M and verify 2150-04
Test Step 2.
is active.
2150-04 Code Not Active -
Troubleshooting complete.
Test Step 2. Test Signal Voltage to
Sensor.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
2. Disconnect cab lower wiring har-
ness connector P-C51 (WP 0009,
Figure 118) from LH joystick con-
nector J1 (WP 0282).
3. Turn ignition switch and battery
disconnect switch to the ON posi-
tion.
4. Using digital multimeter, test for
Voltage Between 11.5 to 12.5 Volts -
voltage between harness connec-
Replace LH joystick (WP 0282).
tor P-C51 (WP 0009, Figure 118)
Proceed to step 5.
terminal 10 and terminal 8. Volt-
Voltage Out of Specifications of
age should be between 11.5 to
11.5 to 12.5 Volts - Proceed to Test
12.5 volts.
Step 3.
2150-04 Code Active - Repeat
5. Using MSD (WP 0006), select
troubleshooting code from the
Implement 120M ECM and verify
beginning.
2150-04 is not active.
2150-04 Code Not Active -
Troubleshooting complete.
0028-26
